How Do You Replace The Rubber Seal On A Whirlpool Front Load Washer

by

How to Replace the Rubber Seal on a Whirlpool Front Load Washer

Replacing the rubber seal on a Whirlpool front load washer is a relatively simple task that can be completed in about an hour. By following these instructions, you can save yourself the cost of a professional repair.

Tools and Materials

  • New rubber seal
  • Screwdriver
  • Pliers
  • Bucket
  • Rags

Safety Precautions

  • Unplug the washer from the electrical outlet.
  • Turn off the water supply to the washer.
  • Wear gloves and safety glasses.

Step-by-Step Instructions

  1. Remove the front panel. Open the washer door and remove the two screws at the top of the front panel. Grip the panel at the bottom and pull it straight towards you.
  2. Locate the rubber seal. The rubber seal is located around the opening of the washer drum. It is held in place by a metal clamp.
  3. Remove the metal clamp. Use a screwdriver to loosen the screws that hold the metal clamp in place. Once the screws are loose, you can remove the clamp.
  4. Remove the old rubber seal. Grip the old rubber seal and pull it straight out of the washer. Be careful not to damage the drum.
  5. Clean the sealing surface. Use a rag to clean the sealing surface of the washer drum. Remove any dirt or debris that could interfere with the new seal.
  6. Install the new rubber seal. Place the new rubber seal around the opening of the washer drum. Make sure that the seal is properly seated.
  7. Install the metal clamp. Place the metal clamp around the new rubber seal. Tighten the screws to secure the clamp.
  8. Reinstall the front panel. Align the front panel with the washer frame and push it into place. Secure the panel with the two screws at the top.
  9. Reconnect the water supply and electrical outlet. Turn on the water supply and plug the washer into the electrical outlet.

    10. Troubleshooting

    • The washer is leaking water. This could be due to a damaged rubber seal. Inspect the seal for any tears or punctures.
    • The washer is making a strange noise. This could be due to a loose rubber seal. Tighten the screws that hold the metal clamp in place.
    • The washer is not draining properly. This could be due to a clogged drain hose. Clean the drain hose and make sure that it is not kinked.

    Conclusion

    Replacing the rubber seal on a Whirlpool front load washer is a simple task that can be completed in about an hour. By following these instructions, you can save yourself the cost of a professional repair.

Also Read: What Are The Army Insects

Recommend: How Do You Write A Letter For Community Service Hours Completed

Related Posts: Can Bridge Be Played With 2 Players

Also Read: What Is The Kitchenaid Wire Whip Used For

Recommend: Which Bureau Is Responsible For Minting Coins

Leave a comment