How to Install a Distributor on a Chevy 350

Materials Needed

• New distributor
• Distributor cap and rotor
• Spark plug wires
• Wrench set
• Screwdriver
• Timing light

Step 1: Remove the Old Distributor

1. Disconnect the negative battery cable.
2. Unplug the electrical connector from the distributor.
3. Remove the distributor cap and rotor.
4. Use a wrench to loosen the distributor hold-down bolt.
5. Gently pull the distributor straight up and out of the engine.

Step 2: Install the New Distributor

1. Apply a small amount of grease to the distributor shaft.
2. Insert the new distributor into the engine by aligning the drive gear with the camshaft gear.
3. Tighten the distributor hold-down bolt by hand until it is snug.
4. Reconnect the electrical connector to the distributor.
5. Install the distributor cap and rotor.

Step 3: Set the Timing

1. Connect a timing light to the number one spark plug wire.
2. Start the engine and let it idle.
3. Aim the timing light at the timing mark on the engine’s harmonic balancer.
4. Adjust the distributor until the timing mark lines up with the “0” mark on the timing scale.
5. Tighten the distributor hold-down bolt to secure the distributor in place.

Conclusion

Installing a new distributor on a Chevy 350 engine is a relatively straightforward procedure. By following these steps, you can ensure that your engine is running properly and efficiently.

Also Read: How To Tell If Gucci Bag Is Real

Recommend: How To Store Ripe Peaches

Related Posts: Where Does Sting Live

Also Read: What Happens When Ethyl Benzene Reacts With Br2 In Presence Of Sunlight

Recommend: How To Clean Resin Molds